This the multi-page printable view of this section. Click here to print.

Return to the regular view of this page.

Capabilities

EPRI - PDU Lab capabilities

1 - Lenox T&D Lab

A look into EPRI’s Lenox Transmission & Distribution Laboratory

The Transmission & Distribution laboratory in Lenox, MA provides a unique test facility for a variety of T&D research topics. Explore the laboratory below by clicking the popover (red dots) at a selection for the test sites. Click the popover to keep the popover open.

image/svg+xml
  • Arc Flash
  • Burndown of bare and covered conductors
  • Flammability of equipment under fault condition
  • Damage to crossarms and insulators under fault conditions
  • Performance of sensors during faults
  • Grounding and stray voltages; step and touch voltages during faults
  • Evaluation of vegetation faults
  • Fuse cutout and single-phase recloser performance
  • Conductor slap

Arc flash

23-kV loop

composite-crossarm

The test fixture applies a three-point bending test to composite crossarms. This test includes the capability to enclose the crossarm and elevate the temperature to investigate load-deflection characteristics in extreme heat.

DA Test Area

Outdoor DA test area for long term testing of automation components, to understand the performance overtime.

DA lightning

Lightning and grounding testing up to 800kV to improve distribution automation equipment reliability.

DA lightning

Three phase accuracy test set is used for testing distribution sensors and can be energized at 19.2kV with current from 0A to 600A.

mlv yard

This facility is an MV and LV test area and an outdoor aging yard for distribution assets.

pole-strength

EPRI can configure this multi-purpose test area to perform cantilever pole strength testing. This testing is helping utilities learn more about the quality of pole inspection by comparing field assessment with actual remaining pole strength as determined through laboratory testing.

energized-down

The energized-downed-conductor area has been used to record signatures of live, downed conductors. Several relay and recloser technologies for detecting these high-impedance faults have been tested. Multiple scenarios are available, including multiple voltages and different surfaces.

vehicle-grounding This capability has also been used to evaluate vehicle grounding and what happens when a vehicle becomes energized. This includes step and touch voltages around energized vehicles.

Reconfigurable Transmission Line

Three phase reconfigurable transmission line more than 500 meters long.

impulse-generator

Three impulse generators are located in the EPRI Lenox laboratory, the largest of which is the 5.6MV tower which simulates lighting and switching surges for performing component testing and insulation coordination mapping.

mv-cable

structure testing

Resiliency & reliability testing of full scale distribution structures using simulated tree-strikes and falling branches.

Click here for more info

138kv-yard

Research substation to investigate component, monitoring, and diagnostic performance.

drone yard

Drone test site to understand aircraft and payload performance in electric environments.

above-ground-vault

explosion

lv-cable

Long-term test fixture to understand degradation and inspection methods for low voltage connectors.

composite

Accelerated environmental aging is performed on full scale composite (fiberglass) poles and crossarms as well as small scale samples to determine changes in their mechanical and electrical properties.

stray voltage

Test Facility designed to replicate user defined human and animal perceptible shock scenarios. This includes ability to simulate concerns associated with urban shock hazards, overhead distribution stray voltages and swimming pool electric shock concerns.

new12

EPRI has the capability of performing tests on transmission line insulators with guidance from ANSI C29.2B Section 8.3.4 –“Combined mechanical and electrical strength tests”

new12

The accelerated aging chamber is 40 ft wide × 60 ft long × 20 ft high. A computer-controlled environmental system simulates a defined climate inside the aging chamber by varying temperature, clean fog, salt fog, clean rain, UV radiation, and humidity.

new12

Hover over these links to locate a test site on the map above:

Arc fault tests | Arc flash | DA Full-Scale Test Area | Composite Structure Aging | Composite Crossarm Test Area | MLV Yard | Stray and Contact Voltage Test Infrastructure | Distribution Automation Loop | MV Termination Cable Testing | Pole Strength Testing | Full-scale Structure Tests | Energized Downed Conductor | Vehicle Grounding | 23-kV loop | Reconfigurable Transmission Line | DA Lightning & Grounding | 5.6MV Impulse Generator | Drone Test Yard | 138kV Test Substation | Above Ground Test Vaults | Underground Explosions Tests | Low Voltage Connectors | MTS M&E | Aging Chamber | New 12 stage IG

2 -